“MATLAB and Simulink greatly reduced development cycle time and cut system and software design and testing costs by 50%.”
Feng Liang, BAE Systems Controls
As air vehicle flight control and avionics systems are required to deliver more functionality and perform more complex missions, their onboard software becomes increasingly complicated to design and produce. Flight control systems for unmanned aerial vehicles (UAVs) have the added complexity of autonomous or remote control.
Using MathWorks tools, engineers at BAE Systems Controls in Johnson City, New York, and Santa Monica, California, developed and successfully flight tested a UAV flight avionics system and ground control station in just eight months. The tools enabled the geographically separated teams to design, model, and analyze the control system, simulate the UAV, visualize the simulation data, perform testing, and automatically generate the autopilot code, all in a single environment.
“MathWorks products greatly reduced our development cycle time and cut system and software design and testing costs by 50%,” says Feng Liang, principal engineer at BAE Systems Controls.
Engineers at BAE Systems Controls had to develop and flight test the avionics system and ground control station software for a UAV with an Eagle 150 airframe and a Teledyne Continental Motors IO-240-B engine. Composites Technology Research Malaysia was responsible for overall UAV integration. Excelnet handled the aircraft modification and integration tasks.
UAV system architecture is highly sophisticated and requires the configuration of such items as a vehicle management controller, actuators, data link receivers and transmitters, payload assembly, a GPS receiver, a power generator, and a battery.
Within a limited budget and an aggressive schedule, the BAE SYSTEMS team had to deliver reliable, flight-critical software that would operate remotely from a ground control station and autonomously. They also wanted a design that would allow both the hardware and the software to be cost-effectively migrated to new applications.
The BAE Systems team wanted to use design tools that were widely used, well tested, and fully compatible. They also needed to work in an environment that was well suited to Model-Based Design.
BAE Systems chose MATLAB®, Simulink®, and Stateflow® to model the UAV system. They decided to save time and costs by reusing existing software designs. These designs included an autopilot model, developed using MATLAB, Simulink, Stateflow, and an integrated navigation algorithm.
For their new system, the engineers needed to include a six-degrees-of-freedom nonlinear dynamic model of the Eagle 150 aircraft with all variables computed as outputs. They also needed models for atmosphere and turbulence, the landing gear, the steering wheel, control surfaces, actuators, sensors, engine speed, exhaust gas temperature, propeller thrust, and a data link. The existing autopilot model included flight phase and mode logic; longitudinal, lateral, and directional loop control; throttle and fuel mixture control; guidance and navigation data computation; and engine status monitoring.
Simulink Coder™ was used to automatically generate the embedded software from the Simulink and Stateflow models. Documentation of the system and software designs was automatically generated from the same models as those used to generate the code and verify the simulation.
The engineers quickly resolved flight test issues by logging and identifying problems and then modifying the Simulink model, testing the new requirements by simulating the model, automatically generating code, and conducting hardware-in-the-loop testing and a flight test checkout. New functionality was added to the system in a similar way.
The first monitored flight of the UAV was a great success. The basic autopilot functions were checked and found to be satisfactory. System requirements were validated during additional flight tests.
Enable teams working in separate locations to design a sophisticated UAV autopilot system quickly and inexpensively
Using MathWorks tools for Model-Based Design, modify existing software designs in a single environment and then automatically generate embedded control code